OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2761

Torque Converter Clutch Pressure Control Solenoid Control Circuit/Open

P2761 says the TCM has lost continuity to the converter clutch pressure solenoid. GM documents the check in its six-speed TCM tables (16OBDG08 for the MW7 unit in Silverado/Sierra, 18OBDG04 for the T87A): with the driver switched off, an impedance of 173 kΩ or more counts as open, while 9.6 kΩ or less does not; after three hardware counts an intrusive test opens the low-side driver, and two confirming counts set the Type B code. The same tables block the stuck-off test P0741 while P2761 is pending. On 2023 Ram heavy-duty trucks with the 6.7 l Cummins, bulletin 1807223 lists P2761 among codes caused by a leaking capacitor inside the engine controller, so the solenoid is not always to blame.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 61

Possible causes

  • Broken wire or backed-out pin to the solenoid high
  • Open solenoid winding medium
  • Internal controller fault (Ram 6.7 l ECM capacitor leak) low

Symptoms

  • No torque converter lockup
  • MIL on after two trips (GM Type B)
  • Higher cruise rpm and fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2761

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication