OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P275F

Transmission Fluid Temperature Sensor D Over Temperature Condition

P275F is the overheating condition for sensor D: the reading is valid and above the calibrated limit. No manufacturer documents the code, the limit or where sensor D sits. The sensor A equivalent P0218 gives an idea of the logic – Saab's Aisin automatic sets it beyond 170 °C lasting over ten seconds and recommends fresh fluid afterwards, because overheated oil loses its additives. A transmission that reports heat at a fourth measuring point is usually working at its edge: heavy trailer, steep climbs, slipping clutch or converter, or a cooler that cannot keep up. The module typically protects itself with altered shifting or less torque; the code is not an electrical fault, so check fluid and cooling first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 5F

Possible causes

  • Heavy trailer or long steep climbs high
  • Slipping clutch or torque converter medium
  • Cooler blocked or not keeping up medium

Symptoms

  • Overheating warning or message
  • Changed shifting or reduced power
  • Dark or burnt-smelling fluid

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P275F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication