P275C
Transmission Fluid Temperature Sensor D Circuit Low
P275C reports that sensor D delivers less signal than the module considers possible. Read against an NTC thermistor this means a reading far hotter than the fluid could be, which almost always points to a pinched or melted lead touching ground, or to a short inside the sensor body. P275C is not documented by any manufacturer. As a frame of reference, GM's 2023 dual-clutch TCM judges its sump sensor too low below 200 mV for 500 ms. Mitsubishi shows that the meaning can also be inverted, since its dual-clutch unit sets the sensor B low code at −40 °C or colder. Before replacing parts, unplug the sensor: if the value jumps to the cold end, the fault lies in the sensor, otherwise in the harness.
Possible causes
- Pinched or melted lead of sensor D touching ground high
- Short inside sensor D medium
- Module input faulty low
Symptoms
- Warning lamp
- Temperature D shows an impossibly hot value
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P275C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.