OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2759

Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical

P2759 is a general electrical fault on the control circuit of the converter clutch pressure solenoid, used where a module cannot distinguish an open from a ground or supply short. No manufacturer documents P2759 publicly. The principle is visible in Ford's 2012 summary: the TCC output is pulse-width driven and a feedback line from the driver reveals opens and shorts, while makers such as GM report each case separately under P2761, P2763 and P2764. CARB requires this circuit check for transmission outputs. A meter test of coil resistance and of each wire to ground and to battery usually narrows it down quickly. Until repaired, many controllers inhibit lockup, so cruise rpm and fluid temperature rise slightly.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 59

Possible causes

  • Damaged wire or connector between TCM and solenoid high
  • Solenoid coil open or shorted medium
  • Faulty TCM output driver low

Symptoms

  • No converter lockup
  • Slightly higher fuel consumption
  • Warning lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2759

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication