OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2754

Transmission Fluid Cooler Control Circuit Low

P2754 reports that the drive line to the transmission fluid cooling actuator sits at too low a voltage, which in practice means a short to ground or a heavily loaded output. The module then cannot switch the coolant valve or cooler control as intended, and depending on design the valve may remain permanently open or closed. No manufacturer documents P2754 publicly. Audi applies the neighbouring open-circuit code P2753 to the cooling valve on the 2023 Q7 and SQ7, which shows where the fault sits; CARB requires output components to be monitored for shorts as well as opens. Typical culprits are chafed insulation touching the body, water in the connector or a shorted winding. Many output stages shut themselves off to protect against overload.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 54

Possible causes

  • Control wire chafed through and shorted to ground high
  • Water or coolant in the valve connector medium
  • Shorted turns in the valve coil medium

Symptoms

  • Check engine lamp on
  • Fluid temperature higher or lower than normal for the conditions
  • Usually no change in shift behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2754

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication