OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2753

Transmission Fluid Cooler Control Circuit/Open

P2753 is set when the control module finds no closed circuit to the actuator that regulates transmission fluid cooling, usually an electrically switched coolant valve that opens or shuts the flow of engine coolant through the fluid heat exchanger. With the valve output open, the module cannot steer warm-up or cooling of the gearbox oil. Audi uses the code on the 2023 Q7 and SQ7: diagnostic notice AOS-26-09 of February 2026 supplies a tester hotfix because P275300 was stored without a matching guided test. Under CARB rules such an output must be checked for circuit continuity. Unlike P2754 and P2755 no short is involved, only missing continuity from a broken wire, loose pin or burnt coil. Fluid may run hotter under load or warm up more slowly.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 53

Possible causes

  • Open coil in the transmission fluid cooling valve high
  • Loose or corroded connector at the valve, often after coolant contact medium
  • Broken control wire between module and valve medium
  • Faulty output stage in the control module low

Symptoms

  • Check engine lamp on
  • Transmission fluid warms up slowly or runs hot when towing
  • Transmission overheat warning in severe cases

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2753

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication