P2752
Intermediate Shaft Speed Sensor C Circuit Intermittent
P2752 flags a sensor C circuit that cuts out now and then, briefly enough that neither the circuit code P2749 nor the no-signal code P2751 matures. No manufacturer documents P2752 publicly. The closest published counterpart is Ford's P2748 for sensor B on its ten-speed automatics, an intermittent check that runs continuously beside the circuit and plausibility tests. CARB expects every such transmission input to be monitored for circuit faults. In practice the culprit is mechanical stress on the wiring: a terminal that loosens when hot, insulation worn through on a bracket, or water that wicks into the plug. Watching sensor C while flexing the harness, and reading the freeze frame, are the most useful steps.
Possible causes
- Terminal losing contact when hot high
- Insulation worn through at a bracket or edge medium
- Water ingress into the connector medium
Symptoms
- Sporadic warning lamp
- Occasional rough shift
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2752
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.