OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2751

Intermediate Shaft Speed Sensor C Circuit No Signal

P2751 is reserved for a sensor C that sends no pulses at all while the vehicle is demonstrably under way. No manufacturer documents P2751 publicly. For comparison, Ford's intermediate shaft logic treats a reading below 250 rpm as missing – for 2.5 s on the 2024 ten-speeds, for 5 s on the 2012 transmissions – and it only runs once turbine and output speeds prove that the gearbox is turning. Unlike the circuit code P2749, nothing has to be electrically wrong: a sensor whose electronics have quit, or a toothed wheel that has shifted away from the sensor face, also ends in silence. Expect the module to switch to a substitute speed or a limp-home gear, and confirm on a test drive with the scan tool showing sensor C.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 51

Possible causes

  • Sensor C electronics failed high
  • Open circuit or disconnected plug medium
  • Reluctor missing, loose or too far from the sensor low

Symptoms

  • Warning lamp during the drive
  • Limp-home gear or missing shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2751

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication