P2750
Intermediate Shaft Speed Sensor C Circuit Range/Performance
P2750 says that sensor C produces pulses whose speed is implausible – it disagrees with what the engaged gear and the other shaft speeds predict, jumps too fast or carries noise. No manufacturer documents P2750 publicly. The published checks for neighbouring sensors show what such a test looks like: GM's 2023 dual-clutch TCM compares its clutch 2 sensor with engine speed when the clutch is locked and faults it at 150 rpm difference for 1.1 s, and Ford counts dropouts and noise spikes on sensor B and flags a gear mismatch after 2.5 s. A mechanical cause is just as possible as an electrical one: swarf on a magnetic sensor tip, a cracked reluctor, or slipping clutches that make the ratio comparison fail.
Possible causes
- Metal particles on the sensor tip distorting the signal high
- Electrical interference on the signal lead medium
- Internal clutch slip making the speeds disagree low
Symptoms
- Check engine light after driving
- Erratic shift points or flare between gears
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2750
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.