OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2749

Intermediate Shaft Speed Sensor C Circuit

P2749 covers an electrical fault in the circuit of a third intermediate shaft speed sensor, C. No manufacturer documents P2749 publicly, and it is unclear which transmission carries three such sensors: Ford's ten-speeds stop at B, and dual-clutch units have only two clutch shafts. CARB requires transmission inputs like this to be watched for broken circuits and readings beyond their span. Following Ford's published logic for sensors A and B, a module would detect an open or a short to ground in hardware within about 1.5 s, independent of driving. The split codes P07C9/P07CA cover low and high voltage separately. If it occurs, start with the live value of sensor C next to the other speeds, then check connector, wiring and sensor resistance.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 49

Possible causes

  • Open or grounded wire between module and sensor C high
  • Sensor C defective medium
  • Transmission control module input fault low

Symptoms

  • Check engine light
  • Harsh shifts or limp-home mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2749

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication