P2748
Intermediate Shaft Speed Sensor B Circuit Intermittent
P2748 records short interruptions in the sensor B circuit that heal before a permanent fault can be confirmed. Ford is the one maker that documents it: in the 2024 OBD summary, P2748 is the intermittent check of intermediate shaft sensor B on its ten-speed automatics, run continuously alongside the circuit code P2745 and the plausibility code P2746 within a 30 s monitoring window. Because the signal recovers, the fault often appears only under vibration, at high fluid temperature or when the harness flexes with engine movement. Freeze-frame data showing speed, gear and temperature at the moment of the dropout narrow the search. Replacing the sensor without checking pins and harness rarely ends the problem; drivers may notice occasional harsh shifts.
Possible causes
- Terminal with weak contact pressure in the sensor or gearbox connector high
- Harness rubbing through and touching ground intermittently medium
- Moisture or corrosion in the connector medium
Symptoms
- Warning lamp that comes and goes
- Occasional harsh shift or shift flare
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2748
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.