OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2747

Intermediate Shaft Speed Sensor B Circuit No Signal

P2747 is meant for the case where sensor B stays silent although the car is clearly moving. No manufacturer documents P2747 publicly. Ford's 2024 summary describes exactly this test for its intermediate sensors – vehicle inferred to be driving under positive torque, yet the sensor shows under 250 rpm lasting 2.5 s – but for sensor B it names only P2745, P2746 and P2748, so Ford apparently files missing pulses elsewhere. For the older single-sensor layout, Ford's 2012 strategy flags the intermediate shaft below 250 rpm for 5 s with turbine and output turning. Typical reasons are a sensor that has died internally, an open supply, or a reluctor that no longer passes the sensor. The module substitutes a calculated speed or goes into limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 47

Possible causes

  • Sensor B failed internally and delivers no pulses high
  • Open supply or signal wire, unplugged connector medium
  • Reluctor ring displaced or sensor not seated in its bore low

Symptoms

  • Warning lamp and transmission message while driving
  • Limp-home mode, often stuck in one gear
  • Rough or missing upshifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2747

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication