OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2746

Intermediate Shaft Speed Sensor B Circuit Range/Performance

P2746 means the sensor B signal exists but does not make sense. GM's 2023/24 dual-clutch TCM uses it for the clutch 2 speed sensor: with that clutch fully closed and no microslip, its speed must equal engine speed, and a gap of 150 rpm or more for 1.1 s sets the code; further tests compare it with the speed derived from the output shaft and watch synchronizer speed during gear engagement (above 200 rpm for 50 ms). GM lists it as Type A, so the MIL comes on at the first failure. Ford's 2024 summary bundles three checks of sensor B here: dropouts (800 rpm lost within 10 ms, ten times), noise (2,500 spikes of 300 rpm within 50 ms) and a mismatch with gear and other sensors lasting 2.5 s.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 46

Possible causes

  • Metal debris on the sensor tip or incorrect air gap to the reluctor high
  • Interference or poor shielding causing signal spikes medium
  • Slipping clutch making the speed comparison fail medium
  • Damaged or loose reluctor ring on the shaft low

Symptoms

  • Check engine light, often immediately
  • Jerky clutch engagement or erratic shifts
  • Limp-home mode or one half of the gearbox disabled

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2746

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication