OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2745

Intermediate Shaft Speed Sensor B Circuit

P2745 is the general circuit code for a second intermediate shaft speed sensor, called B. Such a sensor reads a shaft that turns between input and output, on a dual-clutch box typically the second clutch shaft. Ford's 2024 OBD summary documents it: its ten-speed automatics carry two intermediate sensors (the eight-speeds only one), and P2745 means sensor B has an open circuit or a short to ground, while a short to battery appears as P07C8. These hardware checks mature in roughly 1.5 s and run even when the car stands still. On Ford's TR9070 dual-clutch unit, the even-gear clutch shaft sensor is filed under the same P2745 family. Without the signal the module loses one ratio reference, so harsh shifts or a fixed limp-home gear are likely.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 45

Possible causes

  • Signal or supply lead to sensor B broken or chafed to ground high
  • Corroded or loose pins at the transmission connector medium
  • Internal fault of intermediate shaft speed sensor B medium
  • Faulty sensor input in the transmission control module low

Symptoms

  • Check engine light and transmission warning
  • Harsh or delayed shifts
  • Limp-home mode with a fixed gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2745

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication