OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2743

Transmission Fluid Temperature Sensor B Circuit High

P2743 is the counterpart of P2742: the sensor B signal is above its valid range. In GM's 2023/24 dual-clutch TCM the cooler temperature sensor must exceed 4745 mV for 500 ms, Type B; with an NTC thermistor fed from 5 V that points to a broken wire, an unplugged connector or a short to supply voltage, and the reading looks extremely cold. Ford uses P2743 as the out-of-window-high check of the TR9070 cooler-out sensor. Mitsubishi's 2009 Lancer Twin Clutch SST again reasons in temperature: 150 °C or more for 400 ms sets the code, and it advises checking the CAN bus first because bus faults can produce a false entry. Without B the module can no longer judge the cooler outflow and falls back on sensor A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 43

Possible causes

  • Open circuit – broken lead or unplugged connector at sensor B high
  • Signal lead shorted to a voltage source medium
  • CAN fault or control unit with built-in sensor (Mitsubishi TC-SST) low

Symptoms

  • Warning lamp or transmission message
  • Scan tool shows sensor B extremely cold (GM, Ford) or extremely hot (Mitsubishi)
  • Cooler control falls back on sensor A

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2743

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication