OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2741

Transmission Fluid Temperature Sensor B Circuit Range/Performance

P2741 flags a sensor B signal that is electrically intact but physically impossible or inconsistent. The clearest published test is a rate check: GM's 2023/24 dual-clutch module calls the cooler-outlet reading faulty when its filtered gradient exceeds 700 °C per second, confirmed over five samples, as a Type B code (MIL after two trips). Mitsubishi's Twin Clutch SST in the 2009 Lancer uses a jump of 10 °C or more within 80 ms, lasting 400 ms; there the sensor sits in the transaxle-mounted control unit, so a returning code means replacing the transaxle. Ford lists P2741 as the consistency check of the TR9070 cooler-out sensor. Unlike P2742/P2743 the voltage stays in range; a loose pin or sensor drift is typical.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 41

Possible causes

  • Contact resistance or loose pin causing signal jumps high
  • Sensor B thermistor drifting or responding erratically medium
  • Fault in a control unit with built-in sensor (e.g. Mitsubishi TC-SST) low

Symptoms

  • Warning lamp after repeated detection
  • Fluid temperature B jumps on the scan tool
  • Temperature-dependent clutch or cooler control restricted

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2741

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication