OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2738

Pressure Control Solenoid F Control Circuit Low

P2738 reports a control line on solenoid F that reads too low, which in practice means a short to ground. In GM's 2025 table 25OBDG03A an impedance below 0.5 Ohm between the signal and controller ground, lasting 0.3 s inside a 0.5 s sampling period, is a Type A fault in one trip; the valve there controls a clutch on the nine- or ten-speed, line pressure on the eight-speed or the CVT binary pump. The eight-speed table of 2016 uses the same timing. The Corvette dual-clutch TCM tests the clutch cooling valve with its driver switched on and sets P2738 when the measured pin voltage remains below roughly 1.7 V for 150 ms. Ford's TR9070 labels the same condition shorted switch on the odd clutch cooling valve. A grounded line can energise the valve permanently.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 38

Possible causes

  • Control wire chafed through to ground high
  • Shorted turns in solenoid F medium
  • Fluid or metal debris bridging connector pins medium
  • Faulty TCM output stage low

Symptoms

  • MIL on and fail-safe gear
  • Harsh engagements or clutch drag

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2738

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication