OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2737

Pressure Control Solenoid F Control Circuit Range/Performance

The standard title describes implausible readings on the control circuit of solenoid F that are neither a clean open nor a short. GM's 2025 table 25OBDG03A fills the code with a hydraulic test on its CVT, where valve F switches the binary oil pump between half and full capacity. With the vehicle below 2 mph, accelerator released, engine between 600 and 1,200 rpm, fluid above 50 °C and the garage shift finished, the TCM compares the averaged pressures from the primary and secondary pulley sensors in both pump modes. If the differences stay too large, the valve is judged not to follow its command; GM classes this Type B, so the MIL comes on after two trips. Other makers do not publish P2737. A failed pump valve can reduce clamping pressure and lead to belt slip.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 37

Possible causes

  • Binary pump control valve sticking (GM CVT) high
  • Primary or secondary pulley pressure sensor reading wrong medium
  • Low or degraded CVT fluid medium
  • High resistance in the solenoid F circuit low

Symptoms

  • MIL on after two trips
  • Belt slip, flare or reduced power
  • Whine from the CVT

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2737

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication