P2733
Pressure Control Solenoid F Stuck On
P2733 is the reverse case of P2732: valve F keeps pressure on its clutch after the TCM has commanded it off, so the off-going element still carries torque during the shift. GM checks this on its nine-speed units by watching C6 slip while shifting. If slip stays below 50 rpm for 0.8 s during power downshifts or 0.15 s on any other shift, one failure is counted; three of them give a Type A fault in one trip (18OBDG04, 20OBDG03A). GM shares the logic with P2731, which covers the same check in first gear. Bulletin 21-NA-169 for low-mileage 9T45/50/60 units lists P2731 to P2733 together and, with clean fluid, renews the solenoid assembly together with the valve body. Drivers notice tie-up, flare or harsh shifts.
Possible causes
- Solenoid F held open mechanically (solenoid body) high
- Debris holding the regulator valve in the apply position medium
- Restricted clutch exhaust passage low
Symptoms
- Tie-up or bind-up feel during shifts
- Harsh shifts or engine flare
- MIL on and fail-safe gear
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2733
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.