P2731
Pressure Control Solenoid F
P2731 is the parent code for pressure control solenoid F; the standard title names the valve without the kind of fault. GM gives it a concrete job on its nine-speed (GF9) units, where valve F feeds the C6 clutch and the selectable one-way clutch. The 2020 table 20OBDG03A uses P2731 for a stuck-on check in first gear: when the releasing clutch keeps slipping less than 50 rpm for 0.25 s on a garage shift, 0.8 s on a power downshift or 0.15 s otherwise, a Type A fault is logged. GM bulletins call it solenoid valve 6 performance. PIP5556 (2018 Equinox and Traverse) blames a slow one-way clutch release and advises no repair for intermittent cases; 18-NA-097 and service update N182200080 cure stuck-in-first or hesitation complaints with new TCM software.
Possible causes
- Outdated TCM calibration (GM 9-speed, 18-NA-097, N182200080) high
- Selectable one-way clutch releasing too slowly medium
- Solenoid F or its regulator valve sticking medium
- Contaminated or low transmission fluid low
Symptoms
- Hesitation or weak acceleration from low speed
- Tie-up feel on the 1-2 shift or stuck in first gear
- MIL on, sometimes only intermittently
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2731
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.