P2730
Pressure Control Solenoid E Control Circuit High
P2730 is stored when the control line of solenoid E sits too high, pointing to contact with a supply voltage. GM's Allison 1000 logic looks for a power short at the PCS 1 output and treats it as Type A. Its 2016 six-speed tables word the code as circuit high for an open or a power short, so there a broken wire may show up as P2730 instead of P2727. The 2023 Corvette dual-clutch TCM switches the driver on and compares the sense voltage with a limit that depends on supply, about 0.7 V at low and 1.1 V at high battery voltage (Type A); Ford's TR9070 calls the same fault shorted load. No public bulletin links P2730 to a particular repair, so standard tracing of harness, connector and solenoid applies.
Possible causes
- Control wire chafed against a supply circuit high
- Open line on units that report it as high (GM six-speed) medium
- Defective solenoid E medium
- TCM driver fault low
Symptoms
- MIL on and transmission in fail-safe
- Harsh or missing shifts
- Code sets again immediately after clearing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2730
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG08 Transmission Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG03 Transmission Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2023/23OBDG07.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBDSM2400OUTPUT_16Jul2024_WSM_final_V2_MCS7001.pdf