P272D
Park Pawl Motor Control Circuit Current Too High
P272D reports overcurrent in the park pawl motor circuit, the counterpart of P272B for the second winding. Mitsubishi's 2022 Outlander CVT service data sets it with ignition on when one of two phases of motor B that ought to carry current sits at the idle voltage level instead of near 0 V, the pattern of a line shorted to supply. As with P272B, the causes list shorts to power on both coil A and coil B plus the shift module, so the code number alone does not isolate the winding. The response is immediate: shifting is locked out and the powertrain is held in neutral, the MIL lights and, depending on speed, the shift warning lamp as well. A motor that draws too much current may also leave the pawl unable to reach its end position.
Possible causes
- Motor coil B or A phase shorted to power high
- Chafed harness at the shift actuator medium
- Electric shift control module fault low
Symptoms
- Shifting locked out, vehicle held in neutral
- MIL and shift warning lamp on
- Park may not engage fully
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P272D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.