P272B
Transmission Range Select Motor Control Circuit Current Too High
P272B flags excessive current in the circuit of the range select motor, normally caused by a winding or wire shorted to supply. On the 2022 Mitsubishi Outlander with CVT, Mitsubishi checks this with ignition on: when one of the two phases that should be energised shows the non-energised voltage level (9-16 V instead of about 0 V), the code is set. The service text lists short circuits to power on either the A or the B winding, the connectors or the electric shift module as causes, so the code does not prove which winding is at fault. Unlike the open-circuit code P272A, the fail-safe is drastic: shifting is prohibited and the powertrain goes to neutral. The MIL comes on, and the yellow shift warning depends on road speed.
Possible causes
- Motor coil A or B phase shorted to power high
- Damaged harness between shift module and actuator medium
- Electric shift control module fault low
Symptoms
- Vehicle stays in neutral, no gear can be selected
- MIL and shift system warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P272B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.