P272A
Transmission Range Select Motor Control Circuit
P272A refers to the control circuit of the electric motor that moves the gearbox into the selected range in shift-by-wire designs. Mitsubishi documents it for the 2022 Outlander with CVT: the shift actuator has two three-phase windings fed through separate relays, and motor A is the one reported as range select motor. With ignition on and the actuator at rest, a phase that reads low although no phase is energised sets the code; a second test after ignition off turns relays A and B off in turn and briefly rotates the motor. Listed causes are an open relay A circuit, an open phase wire, a relay stuck off, the coil or the electric shift module. If only one winding fails nothing changes for the driver; with both lost shifting is blocked and the drivetrain goes to neutral.
Possible causes
- Shift actuator relay A open or stuck off high
- Open U, V or W phase wire to motor A medium
- Faulty motor coil A in the shift actuator medium
- Electric shift control module fault low
Symptoms
- MIL and shift warning, often no change in driving
- Gear selection refused, vehicle in neutral (second fault)
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P272A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.