P2728
Pressure Control Solenoid E Control Circuit Range/Performance
P2728 marks the circuit of solenoid E as working but not plausible. GM uses it in two ways. On the Allison 1000 (16OBDG08, 17OBDG04) the TCM compares desired with actual current on PCS 1; a gap of at least 0.5 A in 10 of fewer than 20 samples sets a Type A fault with MIL. On the T76 six-speed table of 2016, where valve E serves the 1-2-3-4 clutch, an invalid voltage flag for 4.4 of 5 s sets it without MIL. Bulletin PI0893 explains the second case for 2013 vehicles with the 6T70/6T75: as a Type C history code next to P2719 and P0965 it can appear falsely with fluid between -0.5 and 0 °C in Park or Neutral and needs no parts. MIL behaviour therefore depends on the gearbox.
Possible causes
- Coil current deviating from command (resistance change, poor contact) high
- False history code near 0 °C fluid temperature (GM 6T70/6T75) medium
- Unstable supply voltage to the TCM low
- Worn solenoid E low
Symptoms
- MIL on Allison-equipped trucks
- History code without symptoms on GM six-speeds
- Firm shifts if pressure control is degraded
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2728
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.