OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2725

Pressure Control Solenoid E Electrical

P2725 covers an unspecified electrical fault of pressure control solenoid E. The driver notices a coil current or voltage that does not fit the command but does not classify it further. No manufacturer documents P2725 publicly. GM splits the electrical checks of valve E into P2727, P2729 and P2730; on the Allison 1000 these are Type A tests on the solenoid GM calls PCS 1, including a ground-short check every 6.25 ms. Ford's 2024 summary uses the same three codes for its TR9070 line pressure pilot valve. CARB demands circuit monitoring of transmission solenoids. A controller using P2725 would point to the same suspects: coil, connector, harness or driver. Depending on the gearbox the result is a default gear or a pressure fallback.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 25

Possible causes

  • Faulty coil in solenoid E high
  • Corroded or loose connector medium
  • Damaged wiring between TCM and solenoid medium
  • Defective TCM output stage low

Symptoms

  • MIL lit and default gear
  • Firm shifts from fallback pressure
  • Code returns at once if the fault is permanent

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2725

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication