OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2724

Pressure Control Solenoid E Stuck On

P2724 flags valve E as delivering pressure when it should not, so its clutch stays engaged too long. On the Allison 1000 GM watches the off-going element during shifts: an accumulated fail time of 0.3 s on upshifts, 0.5 s on closed-throttle downshifts or 3 s on direction changes counts as stuck on (Type A). On the nine-speed the check runs through exhaust-delay tables for clutch C5, on the eight-speed through torque and inertia phase tests on clutch 5. The 2023 Corvette dual-clutch TCM reverses the sense for its system pressure pilot valve: a pressure 3 bar below target means stuck on, rated Type B. GM's PIP5646 links P2724, P2727 and P2729 on 2019-2020 Silverado and Sierra 8L90 to rear wheels locking after a hot soak, cured by a new TCM.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 24

Possible causes

  • Valve or regulator held in the applied position by debris high
  • Internal TCM fault (GM 8L90, PIP5646) medium
  • Solenoid E mechanically stuck medium
  • Restricted clutch exhaust passage low

Symptoms

  • Wheels lock or vehicle stops abruptly at low speed
  • Tie-up or harsh shift feel
  • MIL on, transmission may hold a safe gear

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2724

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication