OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P271F

Electronic Gear Shift - Position Not Learned

P271F tells the technician that the controller of an electronically actuated gear shift lacks valid learned positions, so it cannot place the shift elements precisely. Automated and dual-clutch gearboxes store the end and engagement points of their actuators; after replacing a control unit or mechanical parts, or after the stored values are lost, these must be learned again with a scan tool or during a defined drive. The code is a status message rather than a defect report. No manufacturer documents P271F publicly. Volkswagen's 0AM DSG booklet shows the underlying idea: its control unit adapts where both clutches and each gear selector sit whenever a gear is engaged. Unlike P0914 or P0919, which point to the selector position circuit or its control, P271F concerns missing calibration.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 1F

Possible causes

  • Learn procedure not run after replacing the control unit or transmission parts high
  • Learn procedure aborted (conditions not met, low battery voltage) medium
  • Learned values lost after a software update or power interruption medium
  • Actuator or position sensor fault preventing a successful learn low

Symptoms

  • Gearbox warning, gear selection limited or blocked
  • Rough or imprecise engagement
  • Code returns until a successful learn

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P271F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication