OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P271B

Park Pawl Position Sensor A Circuit High

P271B is the upper-limit partner of P271A: the signal from park pawl position sensor A reads above its plausible range. Typical electrical causes are a broken ground or signal wire, which lets the input float towards the reference, or a short to a supply line. No manufacturer documents P271B publicly. The closest published case concerns the same sensor at its lower limit, Ford's recall 26V688 for the Integrated Park Module of the HF55 hybrid transmission, which shows what is at stake: if the controller cannot trust the pawl position it may refuse to leave Park or drop to Neutral. Most systems carry a second sensor B as a cross-check (P271C/P271D), so a single high reading is normally caught before the pawl moves unintentionally.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 1B

Possible causes

  • Open sensor ground or signal wire high
  • Signal wire shorted to reference or battery voltage medium
  • Corroded or loose connector at the park actuator medium
  • Failed position sensor A low

Symptoms

  • Shift system warning on the display
  • Park cannot be selected or released

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P271B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication