OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2717

Pressure Control Solenoid D Intermittent

P2717 reports that the circuit or response of solenoid D drops out briefly and then comes back. Unlike a hard open or short, the fault is gone by the time the vehicle reaches the workshop, so a static measurement often looks fine. No manufacturer documents P2717 publicly. Ford shows the principle on its shift solenoids: the 2024 OBD summary attaches failure byte 1F (circuit intermittent) to the base code, and P2710 is the counterpart for shift solenoid F. Under CARB rules a solenoid circuit must be watched continuously. Typical triggers are spread terminals, a wire rubbing through near the valve body, or moisture in the connector, and the fault often appears only when hot or on rough roads. The gearbox may stay in a substitute mode until the engine is restarted.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 17

Possible causes

  • Spread or loose terminal at transmission or TCM connector high
  • Wire rubbing through intermittently medium
  • Moisture or corrosion in the connector medium
  • Heat-dependent break inside the coil low

Symptoms

  • Occasional harsh or flared shift
  • MIL that comes and goes
  • No fault found during a workshop check

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2717

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication