P2716
Pressure Control Solenoid D Electrical
P2716 is the general electrical code for pressure control solenoid D: the output stage sees a wrong current or voltage on the coil, without saying whether the circuit is open, grounded or shorted to supply. No manufacturer documents P2716 publicly. The makers that publish data on valve D split its electrical checks instead: GM's 2016 eight-speed table uses P2718, P2720 and P2721 with 0.3 s fail times, and Ford's 2024 summary gives the same three codes for open load, shorted switch and shorted load. CARB requires the circuits of transmission solenoids to be monitored as comprehensive components. When a controller does use this broad code, the cause is usually a coil, a connector or the harness, and the gearbox drops into a fail-safe mode with fixed gears.
Possible causes
- Open or shorted coil in solenoid D high
- Loose, corroded or not fully seated connector medium
- Chafed internal or external harness medium
- Faulty driver stage in the TCM low
Symptoms
- MIL lit and transmission in fail-safe mode
- Fixed gear or missing gears
- Harsh engagement after start
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2716
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.