OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2712

Hydraulic Power Unit Leakage

P2712 targets gearboxes whose clutches or shift forks are worked by a separate hydraulic power unit, typically an electric pump that charges a pressure accumulator. Such a system loses pressure only slowly when sealed; if pressure drops faster than expected or the pump has to recharge too often, the controller concludes there is a leak. No manufacturer documents P2712 publicly. The principle is described in Volkswagen's training booklet for the dry seven-speed DSG 0AM: an electric pump fills a 0.2 l gas accumulator, switches off at about 60 bar according to the pressure sensor and restarts near 40 bar. CARB counts automatic transmission controls among the monitored output components. A leaking accumulator, valve or seal can end in lost gears; P0944 covers a general pressure loss of the hydraulic unit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 12

Possible causes

  • Leaking or worn pressure accumulator high
  • Internal leakage at valves or seals of the hydraulic unit medium
  • External oil leak at housing, lines or connector seals medium
  • Implausible pressure sensor signal low

Symptoms

  • Hydraulic pump running often or for long periods
  • Gears not engaging or delayed engagement
  • Gearbox warning and emergency mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2712

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication