OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P270E

Transmission Friction Element E Temperature Too High

P270E reports an over-temperature of the shift element labelled E. Because the value is normally calculated rather than measured inside the clutch, a wrong input can also trigger it: an implausible fluid temperature signal or incorrect slip data from the speed sensors would distort the estimate. Before suspecting the clutch, check for stored sensor codes such as P0711 or speed sensor faults, and confirm the fluid level. If those are fine, real slip of element E under load is the likely reason. No vehicle maker documents P270E publicly; Audi's S tronic bulletin for the 2010-2012 S4/S5 shows a related case under maker codes, where poor contact on the mechatronic circuit board produced clutch temperature and torque limitation entries. The car usually stays drivable with reduced performance.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 0E

Possible causes

  • Faulty fluid temperature or speed sensor signal distorting the calculated temperature medium
  • Real slip of element E under load medium
  • Poor internal contact in the transmission control electronics low
  • Low fluid level low

Symptoms

  • Gearbox warning with reduced performance
  • Additional sensor codes stored
  • Slipping or delayed shifts through element E

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P270E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication