P270C
Transmission Friction Element C Temperature Too High
With P270C the controller reports that clutch or brake C has run hotter than its permitted limit. Typical triggers are long slip phases: creeping in heavy traffic, holding the car on a slope with the throttle, or a trailer launch. If the situation keeps recurring under normal driving, the element itself may be slipping because apply pressure is low or its linings are worn, and the fluid should be checked for level, smell and debris. There is no public maker documentation for P270C; which element carries letter C must be taken from the gearbox's own clutch chart. Audi documents the same protective idea under its own codes for the S tronic of the S4/S5 (2010-2012), where a fault in the clutch cooling oil valve can appear together with the clutch temperature entries. Sibling codes P270A to P270F differ only in the element.
Possible causes
- Creeping or holding on a grade with the throttle instead of the brake high
- Element C slipping from low apply pressure or worn plates medium
- Faulty clutch cooling oil valve or restricted cooler (where fitted) medium
- Low fluid level low
Symptoms
- Warning in the cluster with reduced power
- Gear using element C avoided or held only briefly
- Hot, darkened fluid
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P270C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.