OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2708

Shift Solenoid F Stuck On

P2708 means the clutch fed by shift solenoid F stays applied when the controller expects it released, although the wiring checks pass. Ford's 2024 OBD summary maps it to P2706 with the failed-on byte 7E for its 10R60/10R80, 8F35/8F40, 8F57 and 8F24 units. One bad event lasts roughly 2.5 s outside a shift or 1 s during one; each adds 3 to a counter, each correct reading removes 1, and 9 stores the code. Since a ratio test cannot separate valve and clutch, Ford's 10R80 bulletins (21-2315 up to 26-2395) treat it as a hydraulic fault, e.g. a shifting sleeve on the CDF clutch cylinder that leaks oil. Audi bulletin 2078831 lists P270800 with a gear actuator fault on 2025 A5/Q5 dual-clutch boxes. Expect harsh or late shifts and a lit MIL. P2707 is the opposite case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 08

Possible causes

  • Internal oil leak at a clutch cylinder or sleeve keeping the clutch applied (Ford 10R80 CDF cylinder) high
  • Shift solenoid F mechanically sticking in the applied position (dirt, wear) medium
  • Outdated PCM/TCM calibration; Ford bulletins combine reprogramming with the repair medium
  • Debris or degraded fluid jamming valves in the valve body low

Symptoms

  • Harsh or delayed engagement and shifts
  • MIL lit, often with other stuck-on or gear-ratio codes
  • Binding or shudder as two clutches work against each other
  • Transmission may hold a fixed gear for protection

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2708

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication