P2706
Shift Solenoid F
P2706 is the general code for the sixth shift solenoid, F. Ford's 2024 OBD summary uses it as the base for all shift solenoid F faults in its 10R60/10R80, 8F35/8F40, 8F57 and 8F24 transmissions: with a fault-type byte added, P2706 marks an open, a short to ground, a short to supply, an intermittent connection, stuck off and stuck on, each also carrying its own two-byte code such as P097F, P2707 or P2708. Ford's electrical check flags a fault once the smart driver has reported a wiring problem for 1.5 s. Stellantis calls the same position the MS solenoid on the Ram 68RFE, where bulletin 18-061-20 lists P2706 among codes cleared by new engine controller software. Ford's SSM 54595 names it with P2707 on 8F35 units that will not leave Park. Shifts involving the related clutch become harsh or are blocked.
Possible causes
- Open or shorted wiring or connector to shift solenoid F, often inside the transmission high
- Failed shift solenoid F or main control valve body medium
- Control module software that needs reprogramming (Ram 68RFE) medium
- Faulty solenoid driver in the PCM or TCM low
Symptoms
- Harsh shifts, missing gears or limp mode
- Vehicle may not shift out of Park on some Ford 8F35 units
- Warning light on
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2706
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.