P2700
Transmission Friction Element A Apply Time Range/Performance
Automatic transmissions shift by filling and releasing clutches or brakes, the friction elements, and the controller learns how long each one takes to apply. P2700 is set when element A engages too slowly, too quickly or not plausibly compared with the commanded shift. Which part A is depends on the gearbox. Ford's 2012 OBD summary notes that its newer units replaced these clutch-level codes with solenoid stuck on/off codes for service, yet Ford still uses P2700: bulletin 16-0057 links it with P0751 and P0730 on TorqShift units built up to 15 December 2015 in E-Series, Super Duty and F-53/F-59 chassis and renews the cylinder of the coast clutch together with its one-way clutch. On Roush's propane Ford chassis the code is MIL on the E-450 and non-MIL on others. Harsh or slipping shifts are typical.
Possible causes
- Worn or damaged clutch A components, such as a cylinder, piston seal or one-way clutch high
- Sticking valve or solenoid in the main control valve body medium
- Low, aged or incorrect transmission fluid medium
- Adaptive shift values not relearned after repair or software update low
Symptoms
- Harsh, delayed or slipping shifts involving clutch A
- Check engine or transmission warning light on
- Incorrect gear ratio codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2700
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.