OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26FF

Auto Configuration Throttle Input Not Present (Bank 2)

Some engine controllers set themselves up at power-on by checking which inputs are connected, so one module can serve several engine layouts. On V engines with a separate throttle body for each cylinder bank this includes a throttle position signal per bank. P26FF means the controller expects a throttle input for bank 2 but finds none during this self-configuration; P063E is the same finding for bank 1. Unlike circuit codes such as P0222/P0223, which judge a signal that is present but wrong, this one says the input was not detected at all. No manufacturer documents P26FF publicly. CARB requires throttle position inputs to be checked for wiring faults and for plausibility. Typical causes are an unplugged throttle body, an open signal wire or software meant for another engine; expect a reduced-power mode.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / FF

Possible causes

  • Bank 2 throttle body connector unplugged or not fully seated high
  • Open signal, reference or ground wire to the bank 2 throttle position sensor medium
  • Engine controller programmed or replaced with software for a different engine variant low

Symptoms

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor throttle response or rough idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P26FF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication