P26FB
EGR Cooler Bypass Control Stuck Closed (Bank 1)
A diesel engine routes recirculated exhaust around the EGR cooler while it is cold, so that the gas warms the engine and aftertreatment; later the bypass flap closes and the gas passes through the cooler. P26FB means the bypass on bank 1 does not open when commanded and stays in the closed, cooling position. FCA uses the code on the 3.0 L EcoDiesel (Ram 1500 2020, Jeep Wrangler). STAR case S2018000001 links it to a 0.6 mm brass restrictor that clogs inside the vacuum line running from the remote solenoid to the flap actuator; the tube must be replaced rather than cleaned, and the actuator is checked by hand for sticking. FCA's PCM software bulletins 18-008-21 and 18-002-23 list P26FB among the codes they address. CARB lists the bypass among parts that must respond during cold-start strategies, so warm-up emissions rise.
Possible causes
- Blocked orifice or kinked vacuum line to the bypass actuator high
- Bypass flap sticking from soot and deposits medium
- Faulty vacuum solenoid or weak vacuum supply medium
- Outdated PCM calibration with too sensitive detection low
Symptoms
- Check engine light on
- Longer warm-up of engine and exhaust aftertreatment
- Usually no noticeable change in driveability
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26FB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.