P26F7
Coolant Pump C Supply Voltage Circuit
Unlike P26F4 to P26F6, which concern the control signal, P26F7 points to the power feed of coolant pump C: the voltage arriving at the pump is missing or implausible. A blown fuse, a relay with burnt contacts, a broken feed wire or a loose ground are the usual causes; a weak battery during cranking can also trigger it. No manufacturer documents P26F7 in public. Ford shows how such a supply fault is detected for its electric engine coolant pump: under P26D3 the PCM concludes that the feed has failed when pump communication is lost and coolant temperature still rises by more than 10 °C. CARB requires electrical faults of monitored components to be found. Without power the pump stops completely, so the loop it serves – heater, low-temperature or component cooling – loses flow until the feed is restored.
Possible causes
- Blown fuse or faulty relay in the pump C feed high
- Broken feed wire or loose, corroded ground medium
- Low system voltage from a weak battery or charging fault low
Symptoms
- Check engine light on
- Pump C does not run at all
- Further codes for the same fuse or for low voltage
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P26F7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.