OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26F3

Starter Relay B Stuck Off

P26F3 reports that starter relay B does not switch through when commanded, so the start sequence that depends on it cannot complete. It is the one code of this group with a public manufacturer case: an FCA STAR case for the Jeep Gladiator, released in March 2022, describes a check engine light and a no-start with P26F3, P00FD and P0562 stored, caused by loose power cables at the power control relay; tightening them to specification was the repair. That points to a missing supply on the load side rather than a failed relay. Otherwise burnt relay contacts or a coil that no longer pulls in are typical. P26F2 covers the opposite case, a relay B that will not release, and P26E4 to P26E6 its control circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / F3

Possible causes

  • Loose power cable at the relay or power distribution unit high
  • Burnt contacts in starter relay B medium
  • Weak battery or low system voltage so the relay does not pull in medium
  • Open coil in relay B low

Symptoms

  • Check engine light
  • Engine does not start or crank
  • Further codes for low system voltage or battery state

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P26F3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication