P26F1
Starter Relay A Stuck Off
P26F1 is the opposite case to P26F0: the module commands starter relay A on, but the expected reaction never arrives, so the starter receives no power. Possible reasons are burnt or contaminated contacts, a coil that no longer pulls in, or a missing feed on the load side, for example a blown fuse or a loose battery cable at the relay. No maker documents P26F1 publicly. As reference points remain FCA, whose Jeep bulletins treat its two starter relays as separately monitored outputs and describe intermittent no-crank conditions, and GM, whose 2018 tables monitor the starter relay A driver. Because a dead relay looks like a dead starter, check whether the starter terminal receives voltage during cranking before replacing the motor.
Possible causes
- Burnt or dirty contacts in starter relay A high
- Blown fuse or loose power cable on the load side of the relay medium
- Relay coil no longer pulling in medium
- Feedback wire to the module interrupted low
Symptoms
- Engine does not crank, or only after several attempts
- Check engine light
- No restart after an automatic stop
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P26F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.