OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26EA

Fuel Pump Control Module B

Vehicles with a second fuel pump give it its own driver module, and P26EA means that module B has reported an internal fault of its own. Ford documents the code in its gasoline OBD summary for 2020 to 2023 and again in 2024 as an internal error reported by the driver module of pump B. Module B reports its state to the PCM as a duty cycle on a fuel pump monitor wire: about 20 % flags invalid control data, 30 % plus or minus 4 % flags the internal error, while 0 or 100 % means no feedback at all (U016C). The check runs continuously at 11 to 16 V battery voltage and needs 2 to 5 seconds. Roush CleanTech's propane systems for Ford E- and F-Series route the same signal through a relay module to the PCM; there the code is non-MIL on the E-450 but MIL on F-650 and F-53. Fuel delivery from pump B may be reduced.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / EA

Possible causes

  • Internal failure of fuel pump driver module B high
  • Open or corroded fuel pump monitor wire between module B and the PCM or relay module medium
  • Poor power or ground at module B low
  • Worn or seized fuel pump B overloading the module low

Symptoms

  • Warning light on, depending on the vehicle calibration
  • Hesitation or power loss at high load
  • Hard starting or stalling if the second pump is needed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26EA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication