OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26E7

Actuator Supply Voltage D Circuit/Open

Supply D is the fourth switched rail with which a control module powers a group of solenoids or other loads, after A (P0657), B (P2669) and C (P2684). P26E7 reports an open load on it. GM's 2023 and 2024 TCM tables assign the code to high-side output 8 and run the check only while the module shuts down: once the output is off and a low-side output on the same load is switched on, the load should pull the line down. If more than 40 % of battery voltage remains, the module keeps the finding in permanent memory and raises the code once it restarts, Type A. Ford's 2024 summary lists P26E7 as the open-load fault of high side driver 8 in the TR9070 dual-clutch gearbox. Everything fed from that rail is without power, so a substitute gear or limp mode is to be expected.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / E7

Possible causes

  • Broken wire or loose, corroded connector between the module output and the loads on supply D high
  • Open coil in a solenoid powered from this rail medium
  • Internal fault in the high-side output of the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • Transmission stays in a substitute gear or limp mode
  • Several solenoid or clutch codes stored at the same time

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P26E7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication