OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26E1

Sensor Power Supply D Circuit High

With P26E1 the fourth sensor supply of the control module reads higher than its regulated value. Deutz assigns it to SPN 3512 with FMI 0, meaning a reading beyond the upper physical limit, rated as most severe. Since the module regulates this output itself, an excessive reading normally comes from outside: a wire of supply D shorted to battery voltage or to another, higher supply, or a sensor feeding voltage back. Raised supply shifts every signal of the sensors connected to it and can damage them, so the module usually reacts strongly. Fewer real-world cases arise than for P26E0, but checking the harness for melted sections near hot or moving parts is the first step. Open circuits on the same output fall under P26DF.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / E1

Possible causes

  • Supply D wire shorted to battery voltage or a higher supply high
  • Faulty sensor feeding voltage back into the supply rail medium
  • Regulator for supply D in the control module defective low

Symptoms

  • Check engine light
  • Implausible readings from several sensors
  • Possible derate depending on the sensors involved

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication