OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26E0

Sensor Power Supply D Circuit Low

P26E0 means the fourth sensor supply output of the control module is pulled below its normal level. Deutz documents it for the fourth ECU sensor supply, SPN 3512, in two variants: excessive current or a grounded circuit (FMI 6), and a reading below the physical limit with top severity (FMI 1). In practice a single sensor with an internal short, or a chafed supply wire touching ground, loads the output so much that the module limits or switches it off. All other sensors on the same rail then lose their feed too. A good strategy is to unplug the sensors on supply D one by one and watch whether the voltage recovers. No other maker publishes the code; CARB requires such supplies to be monitored when emission-related sensors depend on them.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / E0

Possible causes

  • One sensor on supply D with an internal short pulling the output down high
  • Supply wire chafed and touching engine ground medium
  • Moisture in a sensor plug bridging supply and ground low

Symptoms

  • Check engine light
  • Group of sensor faults appearing at once
  • Engine derate or emergency mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26E0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication