P26DF
Sensor Power Supply D Circuit/Open
Sensor power supplies A to D are separate outputs of a control module that feed groups of sensors; they are a different family from the 5 V sensor reference voltages (P0641 and following). D is the fourth such output. P26DF is the general or open-circuit code for it. Deutz uses it in its EMR5/MD1 engine controllers for ECU sensor supply voltage 4 (SPN 3512), with fault types for special instructions and for an unknown root cause, but publishes no thresholds. Other makers do not document P26DF in public. If supply D drops out, every sensor fed by it reports implausible values at the same moment, so a cluster of unrelated sensor codes is the typical picture. Low and high faults of the same output are P26E0 and P26E1.
Possible causes
- Broken supply wire or splice to the sensors on output D high
- Loose or corroded pin at the control module or a sensor medium
- Supply output D inside the control module failed low
Symptoms
- Check engine light
- Several sensor codes stored together
- Reduced power or emergency mode depending on the sensors affected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26DF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.