P26DC
Engine Sound Control A Circuit Low
P26DC reports that the control line of sound actuator A sits at too low a voltage, which points to the wire or the actuator being grounded rather than interrupted. Depending on the design, the driver stage then cannot switch the flap or valve, or switches it permanently because the ground path bypasses it. Ford lists this code in its 2014 powertrain code interpretation with a check engine lamp marking but gives no thresholds; elsewhere no maker publishes details. Typical spots are insulation chafed through on the exhaust, a crushed harness under the car or water inside the actuator plug. Compared with P26DB (open) and P26DD (high), the repair here usually means tracing a bare conductor touching metal.
Possible causes
- Control wire chafed through and touching body or exhaust metal high
- Moisture or corrosion in the actuator connector medium
- Shorted winding inside the sound actuator medium
- Faulty output stage in the controlling module low
Symptoms
- Check engine light
- Exhaust or intake sound does not change between driving modes
- Possibly a blown fuse for the actuator circuit
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P26DC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.