OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26D9

Engine Coolant Pump Clutch Control Circuit Low

P26D9 narrows the electrical fault of the coolant pump clutch down to a control line that sits too close to ground. The output stage in the engine module notices that the voltage on the line stays low when it should be high, which almost always points to a chafed wire touching the engine block or body, a coil with shorted turns, or water in a connector near the pump. There is no published manufacturer description of P26D9. CARB's rule asks for circuit checks on electronic components that influence coolant temperature control, and Ford names clutched water pumps as one such design. Because the solenoid can no longer be switched, the clutch remains in whatever state its springs or magnets give it without current; the driver mostly notices a lit MIL and a changed warm-up, while the short may also blow a shared fuse.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / D9

Possible causes

  • Chafed control wire shorted to ground high
  • Clutch solenoid with shorted windings medium
  • Moisture or coolant in the connector at the pump medium

Symptoms

  • Check engine light on
  • Changed warm-up behaviour of the engine
  • Possibly a blown fuse with further faults on the same circuit

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26D9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication