P26D3
Engine Coolant Pump Supply Voltage Circuit
P26D3 concerns the power feed and ground of the engine coolant pump. On Ford's 2.0 L hybrids the pump module has no way of reporting a loss of these lines, since without power it goes quiet on the LIN bus. The PCM therefore draws a conclusion: if pump communication is lost (U019F) and the coolant has meanwhile warmed by more than 10 °C, it assumes the pump has stopped and sets P26D3 after five seconds; without the temperature rise only the communication code is stored. Ford's Boss 302S code list also contains P26D3. Typical causes are a blown fuse, a failed relay, a broken feed or a loose ground. As the pump does not run, the engine can overheat quickly, so the car should not be driven far.
Possible causes
- Blown pump fuse or failed supply relay high
- Broken power feed or loose ground at the pump medium
- Pump electronics dead so that the pump neither runs nor communicates medium
Symptoms
- Check engine lamp on
- Engine temperature climbing quickly
- U019F stored at the same time
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26D3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.